How to Make a Nipple Mold Using At Home Impression Kit

For Custom Prosthetic or Tattoo Reference Use

✅ WHAT YOU NEED (Included in Your Kit)

  • Part A & B

  • Mixing cup & stick

  • Ziplock bag (for storing the finished mold)

  • Instruction pamphlet

🔧 YOU MIGHT ALSO NEED:

  • Isopropyl alcohol or soap & water

  • Paper towels

  • Timer or clock

IMPORTANT SAFETY NOTES

  • For external use only.

  • Do not apply over broken, irritated, or freshly tattooed skin.

  • Perform a skin patch test on your inner arm 24 hours before use.

  • Use in a clean, well-ventilated space.

STEP-BY-STEP INSTRUCTIONS

STEP 1: CLEAN THE SKIN

Gently wash the nipple and areola area with soap and water or wipe with alcohol. Pat dry completely.

STEP 2: PROTECT BODY HAIR

If hair is present near the nipple, apply a thin layer of petroleum jelly. This prevents pulling when removing the mold. Shave if possible.

STEP 3: MIX THE SILICONE

  1. Mix equal parts of Part A and Part B into the mixing cup.

  2. Mix for 60 seconds, scraping the sides and bottom.

  3. Apply immediately—pot life is around 6 minutes.

STEP 4: APPLICATION

  • Apply in a standing or sitting up position.

  • Use the provided applicator to spread a thin, even layer over the nipple and surrounding area (about 2 inches beyond the areola).

  • Start with the underside of the nipple working in an upward motion.

  • Press gently to capture details and avoid air bubbles.

  • Keep working in a circular motion until nipple and surrounding area are covered in a thick layer.

STEP 6: LET CURE FULLY

  • Sit still and relax for 7-10 minutes while the mold cures.

  • Try not to move or flex the area.

  • When cured it will not be sticky to the touch

STEP 7: REMOVE THE MOLD

  • Gently lift the edges and peel off the mold in one smooth motion.

  • Rinse skin with warm water to remove residue.

  • Let the mold sit uncovered for an hour before sealing it in the bag provided.

  • Label bag Left and/or Right Breast

WHAT TO DO NEXT

Place the cured mold(s) in a labeled ziplock bag and send it back to Finished Touch for prosthetic nipple creation.